DOIONLINE

DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-10673

Publish In
International Journal of Mechanical and Production Engineering (IJMPE)-IJMPE
Journal Home
Volume Issue
Issue
Volume-6,Issue-1  ( Jan, 2018 )
Paper Title
Tensile Strength of PLA Parts Produced by FDM 3D Printer
Author Name
Juraj Beniak, Peter Krizan, Milos Matus
Affilition
Faculty of Mechanical Engineering, Slovak University of Technology in Bratislava
Pages
7-12
Abstract
Many different types of materials are used for 3D printing. Each material have some advantages and disadvantages, so there is really important proper selection of building material for model or final part production. Published paper present actual results of research. Presented are results of tensile strength measurement on prepared specimens built from ecological PLA plastic material. PLA plastic material is in this time the most used material for 3D printing with Fused Deposition Modeling (FDM) or Fused Filament Fabrication (FFF) technology, because its really good and positive properties and easy processing. This material is also ecological, because is produced from renewable sources, not from crude oil, which pollute our environment. The whole testing and measurement was managed and controlled by a prepared experimental plan. There are selected possible important factors, which are act in the experiment in two or three levels. Presented full factor experiment if based on this input data. The results of measurement were evaluated by selected statistical method as ANOVA is. Index Terms - 3D printing, Rapid Prototyping, Additive Manufacturing, Fused Deposition Modeling, PLA plastic material, Tensile Strength.
  View Paper