DOIONLINE

DOIONLINE NO - IJASEAT-IRAJ-DOIONLINE-14817

Publish In
International Journal of Advances in Science, Engineering and Technology(IJASEAT)-IJASEAT
Journal Home
Volume Issue
Issue
Volume-6, Issue-4, Spl. Iss-2  ( Dec, 2018 )
Paper Title
Tool Wear of Aluminum/Chromium/Tungsten-Based-Coated Cemented Carbide in Cutting Alloy Steel
Author Name
Tadahiro Wada
Affilition
Nara National College of Technology, Nara, Japan
Pages
64-67
Abstract
Coating properties of the (Al, Cr, W)-target are improved by adding tungsten to the (Al, Cr) target. Therefore, in this study, to clarify of the effectiveness of the (Al,Cr,W) -coating film for cutting alloy steel, the tool wear was experimentally investigated. The following results were obtained: (1) The wear progress of coated cemented carbide tool deposited using the (Al,Cr,W)-target was slower than that of the coated cemented carbide tool deposited using the (Al,Cr)-target. (2) The wear progress of the (Al64, Cr28,W8)N-coated tool was slower than that of the (Al60, Cr25,W15)N-coated tool. (3) In the case of the coated cemented carbide tool deposited using the (Al64,Cr28,W8)-target, although the adhesiveness of the (Al64,Cr28,W8)(C,N)-coated tool by adding carbon to the (Al64,Cr28,W8)N-coating film became higher, the wear progress of the (Al64,Cr28,W8)(C,N)-coated tool became faster than that of the (Al64,Cr28,W8)N-coated tool. (4) As compared to the wear progress of the (Al64,Cr28,W8)C-coated and that of the (Al64,Cr28,W8)(C,N)-coated tool, the wear progress of the (Al64,Cr28,W8)C coated tool was slightly slower. For this reason, it was considered that although the micro-hardness of the (Al64,Cr28,W8)C-coating film was lower than that of the (Al64,Cr28,W8)(C,N)-coating film, the average value of the friction coefficient of the (Al64, Cr28,W8)N coating film, 0.26, was about half of that of the (Al64, Cr28,W8)(C,N) coating film, 0.53. Index Terms - (Al,Cr,W)-based-coating film, cutting, tool wear, alloy steel.
  View Paper